Ready-Strip Wash
DIRECTIONS FOR USE:
1. Use immediately after paint or varnish removal.
2. If bottom layers appear intact, or surface is very tacky or gummy, then there is paint or varnish remaining on the surface. Therefore, reuse Back to Nature Paint & Varnish Removers as directed before applying Ready-Strip Wash.
3. Apply Ready-Strip Wash Paint Remover Wash liberally onto the surface. Allow Ready-Strip Wash to stay on the surface approximately 1-2 minutes.
4. Use a cloth, stripping pad or nylon brush to scrub surface with Ready-Strip Wash Paint Remover Wash. On wood, rub back and forth along the grain of the wood.
5. Use a second application where necessary.
6. After surface is clean, wipe down with a dry cloth and let dry a minimum of 24 hours. Surface should be completely dry before refinishing.

7. If after using Ready-Strip Wash Paint Remover Wash, stubborn paint or varnish remains on the surface, reuse Back to Nature Paint & Varnish Remover and repeat application of Ready-Strip Wash where necessary.


SAFETY INSTRUCTIONS: Due to the sensitive nature of certain person’s skin and eyes, chemical resistant gloves and safety glasses are recommended. Avoid eye contact. If eye contact occurs immediately flush with water for 15 minutes. Avoid prolonged and repeated contact with skin. If skin contact occurs, wash with soap and water. Do not take internally. If swallowed do not induce vomiting. Give 1 or 2 glasses of water and call a physician immediately.